FREE SHIPPING ON ANY ORDER. | EXTRA 10% OFF FOR EVERYTHING. SALE ENDS ON 1/31.



Fret Slotting Miter Box Instructions

The Fret Slotting Miter box works with work with StewMac's fret saws and Templates. The two fixed sidewalls keep the saw square, and the two adjustable sidewalls can be set to hold the saw snugly in alignment. The guide bearings move up and down, to adjust the saw for the desired depth of cut. Hold-downs secure your work and eliminate drifting.

Using the Miter Box with our Fret Scale Templates

Attach the fingerboard to the template with double-stick tape. Set the saw depth in a waste portion of the fingerboard, by adjusting the roller bearings up or down until the depth of cut is satisfactory. With the template on the bottom, engage one of the template notches into the indexing pin on the fixed sidewall of the Miter Box. Set the two adjustable sidewalls so that the saw moves freely back and forth in the roller bearings, yet is held firmly from side to side.

     

instruction for fret slotting miter box

 

Once these adjustments are completed, tighten the hold-downs and cut a fret slot. Loosen the hold-downs, lift and move the template/fingerboard to the next notch, and cut the next slot. When all the slots have been sawed, separate the fingerboard from the template.

Using the Miter Box without a Fret Scale Template

It is helpful (but not required) to place a spacer under the fingerboard to replace the template. When using this set-up for custom scale lengths, carefully mark the desired fret pattern on the fingerboard and saw accurately on your marked lines.